Queens HVAC CoProudly serving Astoria & all of Queens, NY

Furnace Installation in Queens, NY

High-efficiency gas furnace installation and replacement, sized with a heat loss calculation and vented right, for homes across Queens.

📞 (929) 702-2132Get a Free Estimate

Your Free HVAC Estimate Request

By submitting this form you agree to be contacted by Queens HVAC Co by phone, text or email about your estimate.

Confidential · We respond the same business day

Replacing a furnace is the one shot a Queens house gets at quieter heat and a lower gas bill for 20 years, and most replacements get sold on brand instead of sizing. A 100,000 BTU furnace in a 1,400-square-foot Woodhaven rowhouse runs in short blasts, wears out the ignitor and never warms the far bedroom. Queens HVAC Co runs a heat loss calculation first, every time.

We install 80 percent and 96 percent furnaces from Astoria across the borough, handling venting, gas and NYC permits. Call (929) 702-2132 or request a free estimate.

Completed furnace installation in a utility room

Furnace Installation Built for Queens Homes and Buildings

Most Queens furnaces sit in basements, and a lot of those basements have a water heater on the same masonry chimney. Moving the furnace to 96 percent condensing with PVC sidewall venting leaves the water heater alone on a chimney built for two appliances. The chimney gets a liner or the water heater gets a power vent. Skip it and the flue rots.

Gas lines in older houses in Jamaica and Flushing were sized for a stove and a 1970s furnace. A new furnace with a bigger burner can starve the line. We check pipe size and inlet pressure before quoting.

Condensate from a 96 percent furnace is acidic and needs a drain or a condensate pump. In a Queens basement with the only drain across the room, that pump is part of the install, not an add-on.

Our Furnace Installation Process, Step by Step

  1. 1

    In-home estimate: heat loss calculation, duct and return inspection, venting and gas check.

  2. 2

    Written proposal: model, AFUE, BTU input, staging, warranty, permit fees.

  3. 3

    Permits filed with NYC DOB where required, gas work coordinated with a licensed master plumber.

  4. 4

    Removal of the old furnace, inspection of the plenum and duct connections.

  5. 5

    Install: furnace, venting, gas connection, condensate handling, new filter rack, thermostat.

  6. 6

    Combustion analysis, gas pressure set at the manifold, temperature rise checked against the nameplate.

  7. 7

    Inspection, walkthrough, warranty registration and haul-away.

Furnace Options That Fit Queens Properties

80 percent AFUE single-stage furnaces where the masonry chimney is lined and the budget is tight. 96 percent two-stage and modulating condensing furnaces with ECM blowers for quiet, even heat. Furnaces from Carrier, Trane, Lennox, Rheem, Goodman and American Standard. Matched evaporator coils for homes adding AC Installation at the same time. For houses ready to leave gas, a cold-climate heat pump under Heat Pump Installation & Repair, or a dual-fuel setup that keeps the furnace for the coldest nights.

What Affects the Cost of Furnace Installation in Queens

  • Efficiency and staging: 80 percent single-stage versus 96 percent modulating.
  • Venting: a chimney liner, PVC runs to a sidewall, or a fix for the orphaned water heater.
  • Gas piping changes and the plumber's permit.
  • Ductwork corrections and a proper return, handled under Ductwork Installation & Repair.
  • Timing: a planned fall install versus a January emergency swap.

Local Conditions Our HVAC Contractors Work Around in Queens, NY

  • Heat season: a furnace replacement in a rental has to happen fast and get inspected faster.
  • Shared chimneys and unlined flues in attached houses.
  • Basements with low ceilings and bulkhead access, which decide the cabinet size.
  • Con Edison and National Grid meter capacity on older gas services.

Preventing and Solving Common Furnace Installation Problems

  • Oversizing: short cycling and cold rooms; solved by the heat loss calculation, not the old nameplate.
  • Orphaned water heater: liner or power vent, never left alone on a big flue.
  • Noisy ductwork: new blowers on old undersized ducts; the returns get enlarged.
  • Condensate freezing in exterior PVC drains, which get routed inside.

What to Expect When You Hire Our Queens HVAC Company

  • Heat loss numbers in the proposal, not a guess from the old furnace label.
  • Permits and inspections handled, with the paperwork left in the house.
  • Combustion readings on the invoice.
  • The first fall tune-up through HVAC Maintenance & Tune-Ups scheduled before we leave.

A Furnace Repair that costs half of a new furnace on a 22-year-old unit gets both numbers in writing. The choice stays yours.

"Furnaces in Queens do not die of old age. They die of the chimney, the gas line and the sizing nobody checked."

Furnace Installation Across Our Service Area

More HVAC Services in Queens, NY

Free estimate

AC Repair

Same-day air conditioner repair across Queens for central AC, split systems and wall units.

Learn more →

Let's get started.

Call (929) 702-2132 or Get a Free Estimate from the HVAC contractor in Astoria, Queens that checks the chimney first.

Your Free HVAC Estimate Request

By submitting this form you agree to be contacted by Queens HVAC Co by phone, text or email about your estimate.

Confidential · We respond the same business day

Queens HVAC Co on 30th Avenue in Astoria, NY

32-07 30th Ave, Astoria, NY 11102 · (929) 702-2132

Call (929) 702-2132Free Estimate